Adcon A720 Uživatelská příručka stáhnout pdf (Strana 36)

CHAPTER 2

System Setup

After you have started the Configurator and logged in (as

described in Step 2 through Step 5 on page 23), select the root

element in the tree (the topmost device) and click Properties. You

can also right-click the base station and select Properties in the

pop-up.

Following parameters can be changed:

•The name of the server; this has no implications to

addVANTAGE or the Internet name of the gateway.

• The network operating frequency and the channel spacing.

These parameters must be identical to those programmed

into the RTUs.

WARNING Don’t change the frequency and channel spacing of

your base station if you have no reason to do so. Apart from the

fact that your network may cease to operate properly (you need to

perform the same changes on each individual RTU in the network),

it might also constitute an infringement to your local or national

radio regulations.

•The poll interval, in seconds (default 900). The poll interval is

the distance in time between two consecutive requests to a

certain RTU. You can also set individual poll intervals for each

device (see also “Adding New RTUs” on page 38).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 145 146

Žádné komentáře

Adcon A720 Uživatelská příručka Strana 36